Products

RTV Liquid Silikon Rubber Potting Silicon Adhesive for Power Mould, Lighting etc

China RTV Liquid Silikon Rubber Potting Silicon Adhesive for Power Mould, Lighting etc, Find details about China Thermal Conductive Silicone Sealant, Two Components Sealant from RTV Liquid Silikon Rubber Potting Silicon Adhesive for Power Mould, Lighting etc

Model NO.
685
Trademark
TBL
Transport Package
Drum
Specification
1: 1
Origin
Guangdong, China
Model NO.
685
Trademark
TBL
Transport Package
Drum
Specification
1: 1
Origin
Guangdong, China
Description
685 series are a double components liquid silicone sealant, with heat conduction and inflaming retarding. It has low viscosity and good flowing properties, cured at room temperature or by heating, also with good thermostability and anti-aging properties, keep good elastic and insulating performance, waterproof and anti-aging properties within a wide temperature range after curing.

Application
This series are widely used for sealing and protection of common electronic components, power modules and circuit boards, vehicle HTD power module, ignition system power module and internet transformers etc.

Technical Data
IndicatorsSpecification
Before CuringSpecific Gravity (g/cm³, 25ºC)A: 1.3-2.0
B: 1.3-2.0
Viscosity (mpa.s, 25ºC)A: 1000-10000
B: 1000-10000
Mixing Ratio (A:B)1:1
Viscosity after mixing (mpa.s, 25ºC)1000-10000
Operating Time (min, 25ºC)30-120
Curing Time (h, 25ºC)24
Curing Time (min, 80ºC)15-60
After CuringMechanical PropertiesDurometer (Shore A)40-70
Tensile Strength (Mpa)≥1.0
Elongation (%)≥65
Electrical PropertiesDielectric Strength (KV/mm)≥20
Dielectric Constant (50Hz)3.0
Volume Resistivity (Ω.cm)≥1x1014
Water Absorption (%)≤0.1
Working Temperature (ºC)-50---250
Thermal Conductivity (w/m.k)0.6---2.0
Flame Retardant RatingUL94-V1 / UL94-V0

How to Use
Weighing: mix A & B components separately, weigh A & B components as per weight ratio 1:1 exactly.
Mixing: put B component to A component, mix evenly, it can be finished by hand or equipment.
Defoaming: defoamed in the vacuum condition.
Potting: clean the surface that needed to be coated, put the rubber into the mould.
Curing: curing at room temperature or by heating. In room temperature, the viscosity of rubber will increased along with time extension, it would double with 40-60 minutes.

Our Service
1. Sample: Sample is free for our valuable customer.
2. OEM: OEM service is provided for our valuable customer.
3. Welcome to visit our factory anytime.
4. Welcome to be our brand "TBL" distributor in your local place.

Our Expo. News
RTV Liquid Silikon Rubber Potting Silicon Adhesive for Power Mould, Lighting etc
 

You Might Also Like