Brake Fluid Tester 
 
 
To Check Fluid Quality:
Press the button for power on, green LED will light up.
Insert the tester into reservoir for a second , then the results will be indicated correctly by LEDs.
Auto power off .
 
 
Indications: 
 
Green: Battery OK, i.e.: No Water Contained in the Brake Fluid
Yellow: Less than 1% of Water Content in Brake Fluid
Yellow/Yellow: Approximately 2% of Water Content in Brake Fluid
Yellow/Yellow/Red: Approximately 3% of Water Content in Brake Fluid;                                             
The Brake Fluid  Should be Changed
Yellow/Yellow/Red/Red: at least 4% of Water Content in Brake Fluid;                                                
The Brake Fluid Must be Changed Urgently, Extreme Danger .
 
 
Instructions:
 
Brake fluid detection pen is based on the change in conductivity to determine the moisture change brake fluid. It shows clearly the extent of moisture contained by the light-emitting diode, high moisture content will lead to lower boiling point, affect braking performance. Red indicates the brake fluid needs immediate replacement, green represents good condition, yellow indicates the state is acceptable but soon replaced.
 
1, the green LED lights = water content in the brake fluid H2O <1.5%, brake fluid qualified
2, the yellow LED lights = brake fluid water content H2O = 1.5% to 3%, can continue to use, test again six months later
3, the red LED lights = water content in the brake fluid H2O> 3%, can not continue to use the brake fluid needs to be replaced
Red LED: change brake fluid
4, LED red flashing: battery replacement
5, LED yellow: low moisture content, check again in six months
6, LED green: brake fluid lines / cell row
 
 
Features:
 
Five LED indicators show the test results more accurate.
Testing DOT 3, DOT4, DOT5 brake fluid
Press the switch to turn on the power, the green LED light that represents the battery properly, the green light does not shine on behalf To replace the battery
Automatic shutdown
 
 
Packing List:
10 pcs x Brake Tester