Single roll slag machine
The multi-piece combination of the tooth roll form is integrally cast, and the size is increased from 500 mm in diameter to 600 mm in diameter, which makes the product structure simple and improves the feeding ability of the large slag block.
The integral bearing seat is a partial bearing seat, which must be disassembled and disassembled, which is more convenient for product maintenance.
The slab is fixed to the adjustable type, so that the particle size of the slag can be adjusted to no more than 25mm. DGS-830 crusher
Drive mode is coupling rotation and chain rotation
The toothed roller adopts high-strength wear-resistant material and has a high continuous service life.
 
A variety of needs for power plants. DGS830 tooth roller is enough for A, B, C, Z
A-type toothed roller: all the roller surface is not rounded to the tooth plate, and the particle size is finer after crushing, which is suitable for occasions with high grain size requirements.
B-type toothed roller: It can be used in the widest range of models. After the roller tooth plate wears out, it can be easily replaced with a new toothed plate.
C-type tooth roller: suitable for seawater slag removal or strong coke slag, the destructive force is stronger than A and B type.

Conducive to the slag in the case of strong coking.
The fascia is designed as a hook-shaped fitting and an adjustable shackle, which does not require bolt fastening, is easy to replace, and is economical to operate.
DGS830 has a high crushing strength and can crush materials with approximate limestone strength.
The slag output varies depending on the ash condition; the ash slag is mixed through the slag crusher
Or when the water spray is used to wash the slag slab, the output can reach 60t/h. When the ash slag is dehydrated and passes through the slag crusher and no water spray is used to wash the raft, the output can reach 20t/h; When the diameter is larger than 200mm, the output will be reduced.