Profession Since 1005-Maydos Felexible Water Proof Tile Adhesive & Grout

China Profession Since 1005-Maydos Felexible Water Proof Tile Adhesive & Grout, Find details about China Tile Adhesive, Tile Glue from Profession Since 1005-Maydos Felexible Water Proof Tile Adhesive & Grout

Model NO.
TA513
Characteristic
Weatherability
Promoter Composition
Curing Agent
Composition
Organic Material
Color
Grey
Appearance
White or Grey
Trademark
Maydos
Specification
International Standard
Origin
China
HS Code
3214109000
Model NO.
TA513
Characteristic
Weatherability
Promoter Composition
Curing Agent
Composition
Organic Material
Color
Grey
Appearance
White or Grey
Trademark
Maydos
Specification
International Standard
Origin
China
HS Code
3214109000
Contact Person:  Mr.Samuel Fu
Mobile:  008613794626769Profession Since 1005-Maydos Felexible Water Proof Tile Adhesive & Grout

TA-513 is a kind of high quality environment-friendly waterborne powder which can be mixed with water and used for bonding ceramic tile on the surfaces of wall, ground and floor. It is easily applied and can achieve an excellent adhesion.

Where to use:
For wall surface: To bond ceramic tile (maximum is 60X60cm) on the concrete or cement sand rendering.

For floor and ground:
To bond ceramic tile or building stone.
For all kinds of damp place; Swimming pool/tanks, water proof roof and balcony, bathrooms etc.

Advantages:
1. Super bonding power, avoid the hollow caused by ceramic tile which contacted with cement;
2. Stable performance, use directly after mix it with water;
3. Strong water retention capacity, no need to soak the tile or wet the wall. Reduce the dosage of adhesive and the load on the building;
4. Good flexibility, resistant to all kinds of impact;
5. Nontoxic, non-radiant, no irritative odor;
6. Special anti-sagging formula, easier application.

Technical Data:
1. Bonding Strength(Mpa):   Standard: ≥0.5
After freeze-thaw cycle: ≥0.5
After dipped into water: ≥0.5
After heat aging: ≥0.5

Application Instructions:
1. Surface Preparation:  The surface should be vertical, flat, smooth and free of dust, grease and other contaminants. ·The new cement mortar surface should be maintained at least 14 days before the application of the adhesive.
2. Application Method:  ·Mix the powder with water at the ratio of 25:6-6.5, and then use electrical blender to stir evenly.  ·Keep the mixture for 5 to 10 minutes, and then stir it again to achieve the best result.  ·Finally apply the adhesive on the surface with the notched scraper, and then put the ceramic tile on the surface and press.