2015 must New design 60A MPPT Solar Controller

Support a wide variety of system designs
Must PC1600 Charge Controllers truly represent innovation in Maximum Power Point Tracking (MPPT) technology, which enables them to increase the yield from a solar photovoltaic (PV) array as much as 30% over conventional designs. PC1600 Charge Controllers support a wide variety of system designs, battery chemistries, and integrate seamlessly in terms of system data management and programming.

PV system designers met the challenge of delivering both grid-tied savings during normal times and off-grid independence during emergencies with 1-phase arrays of Must IPV3000W/IPV5000W inverter/chargers powering your house. This system saved money on utility bills, supply essential power during emergencies (all with one versatile system).

Features:
· 45A/60A MPPT solar charge controller
· 24V/48V auto work
· PV Output: 70V-145V
· Several seconds tracking speed
· High Tracking efficiency of 99%
· Multiphase synchronous rectification technology
· Peak conversion efficiency of 98%
· DSP processors architecture ensures high speed and performance
· Multifunction LCD displays system data and status
· Four stages charging optimizes battery performance
Electronic Protections:
· PV array short circuit
· PV over current
· PV over voltage
· PV reverse polarity
· Battery reverse polarity
· Over charging
· Overheating protection

A charge controller's main job is to optimize a PV array's output which can fluctuate based on shading and temperature variables found on the average roof.

Must™ PC1600 Charge Controllers truly represent innovation in Maximum Power Point Tracking (MPPT) technology, which enables them to increase the yield from a solar photovoltaic (PV) array as much as 30% over conventional designs. PC1600 Charge Controllers support a wide variety of system designs, battery chemistries, and integrate seamlessly in terms of system data management and programming.

The innovative PC1600 MPPT software algorithm is both continuous and active, increasing photovoltaic array power yield up to 30% compared to non-MPPT controllers. Thanks to active cooling and intelligent thermal management cooling, both PC1600 Charge Controllers can operate at their full maximum current rating, 40 AMPS or 60 AMPS respectively, in ambient temperatures as high as 113° F (45° C).

PC1600 Charge Controllers incorporate the features developed by Must™ , including support for a wide range of nominal battery voltages and the ability to step-down a higher voltage solar array to recharge a lower voltage battery bank. A built in, backlit 70-character display shows the current status and set the key parameter at the touch of a button.

------------------------------------------------------------------------------------------