Gas/Natural Gas/Biogas/Biomass Generator
Conditions for Using of the Gas/Natural Gas/Biogas/Biomass Generator
1. Temperature of the straw gas used in this biomass generator set should not surpass 40 Celsius when it is 1m or nearer to the pressure regulating valve for air inflow.
2. The pressure that this biomass generator set can sustain ranges from 3kPa to 10 kPa and the fluctuated frequency of the pressure should not surpass 1kPa/min.
3. The granularity of the impurity should not surpass 5 μ M and its max. Content is 30mg/Nm3.
4. For the straw gas used in this biomass generator set, the volume content of H2 should not surpass 20% and the max. Content of H2S, NH3 and tar are 50mg/Nm3, 20mg/Nm3, and 50mg/Nm3.
5. The moisture content in straw gas should not surpass 40g/Nm3 and the heating value of the straw gas should not lower than 4MJ/Nm3.
For gas that cannot reach the conditions above, special allocation will be took for this biomass generator set after evaluation according to the specific composition, pressure, temperature, etc. Provided.

Technologies Used
This biomass generator set uses electrically fuel gas mixing technology, low-pressure air inflow technology, automatic control technology for burning and safe conveying system.
Technical information:
Type: WSFD
Engine Model: 30GF
Rated power: 30kw
Rated Voltage: 400/230V
Rated frequency: 50Hz
Power Factor: 0.8lagging
Rated Speed: 1500r/min
Generator Type:
Phase: AC 3-Phase, 4 wire
Voltage Steady State Regulation: ≤ ± 2%
Voltage Transient State Regulation: ≤ ± 10%
Heat Consumption: ≤ 11386 KJ/kw/h
Oil Consumption: ≤ 1.63 g/Kw/h
Total Displacement: 4.33L
Number of Pot: 4
Diameter of Pot: 105mm
Starting Mode: DC 24V electric motor
Cooling Mode: Water cooling
Lubricating Mode: Passive and flying lubricant
Excitation Mode: Brushless
Controlling System: Automatic alarm system
Guarantee Period: 1 year