Product Description
China High Quality Slurry Pump 

1. General

ZJ slurry pump is high efficiency, energy saving, wear-resisting products, according to the principle of minimum loss design, easy selection, vibration light, low noise. This series of pump flow components using high hardness alloy hybrid material, high abrasion resistance, impact resistance, so as to increase the service life. The pump delivery of the largest concentrations: Mortar 45%, 60% of the pulp. Drive form can use direct coupling, belts, hydraulic, frequency control of motor speed and so on, also may in series or parallel. Shaft seal form mainly pay impeller and packing and mechanical seal. Pump head structure for double hull vertical open, outlet position according to 45 degrees of interval rotating eight different position installation and use.

2. Slurry Pump Notation

200ZJ-I-A60
200-Discharge diameter(mm)
ZJ-Type
I-Single or primary pump
A-Impeller blade number
60-Impeller diameter(mm)

Slurry pump technical table: 
Drive type of Centrifugal Slurry Pump: 
DC Type: The output shaft of a motor is directly connected to the input shaft of a pump via a pump coupler. This type of connection is suitable for applications where the speed of the slurry pump is the same as that of the motor. 

CV Type: The pump is driven by a belt connected to the crankshaft of the engine. This way of connection allows for saving space, easy installation, and fast adjustment of pumping speed. The motor is fixed to the motor support frame which is located on the bearing support above the slurry pump. 

ZV Type: Another type of belt drive that allows easy adjustment of pumping speed. The motor is directly fixed to the bearing support. This way of installation is suitable for motors with larger horsepower than is possible with CV type of installation. Due to the installation of motor onto the bearing support, this method helps save installation space. 

CR Type: This type of belt drive makes it easier to adjust pumping speed. The installation allows both the motor and slurry pump to be fixed to the ground. The motor is installed to the side of the pump. This installation method is suitable for large-power motors.