How to prolong the service life of press felt

Reason of Felt Lint
1.The most common reason is that the surface of the press felt torn loosened by high pressure water.
2.Lack of lubricating water between the vacuum panel and the blanket, which causes the temperature rise and the fiber is damaged.
3.Material of Vacuum suction cover is bad,large in friction coefficient, the edges of the cover and the seam has burrs or with sharp blade shaped, without rounding out the edges,the wrap Angle between the vacuum box and blanket is too large, high vacuum degree, local surface irregularities,fixed screw exposed,the above will lead to felt abrasion .
4.Supporting roller surface with burrs, iron molds , the roller surface wrapped with slurry, or expander roller rubber thread stand is too high or stand has obvious edges and corners,no sharp edges exists between eight openings and rubber roller body or the high and low transition zone is too short, etc are likely to cause blanket abrasion .

Solution of Felt Lint
1.For paper machine especially middle speed or high speed paper machine,the rational use of lubricating water now only benefit to the clean degree of the blanket but also produce a water film between the vacuum panel and blanket which play a role as a lubrication, sealing and cooling effect.
2.Vacuum panel slit between the two strips should be used the same material as the panel material or lower wear-resisting performance than the panel material. From the outside of the vacuum area from dense to sparse and with appropriate amount of lubricating water.
3.All supporting roller surfaces should be smooth without burrs and rust,and copper rollers, stainless steel rollers and rubber rollers are options.
4.There is a speed difference between the relevant transmission points, causing the blankets to rub and wear out.Adjust the speed ratio of each transmission point correctly to avoid the abnormal speed difference.

Application and Structure of Press Felt

Application
1.As a dehydrating medium, when the paper web is dewatered in a vacuum oven and press area, paper making felt to absorb and filter water out the sheets coming off the water.
2.Smooth the paper sheet, smooth the paper sheet surface in transfer and dehydration process.
3.Function of the transfer belt, the network department passes the paper to the drying cadre through the press section, and drives the passive roller and cage operation.

Structure
BOM Felt is composed of bottom net layer and fiber layer. The bottom mesh layer is made of monofilament, monofilament and multifilament composite chemical fiber materials. The single layer, double layer, multi-layer (1 + 1, 1 + 2, 2 + 2) and other organizational structures are made by using different weaving technologies; the common synthetic fibers in the fiber layer mainly include nylon staple fiber, polyester staple fiber and other fiber raw materials; the staple fibers with the same or different thickness are laid in layers on the bottom net, and then The bottom mesh layer and fiber layer are processed by needling, heat setting and other special post finishing processes to make BOM felt.

Felt Parameter

Packing & Delivery

Related Production

1.Forming Fabric 

2.Dryer Fabric 

3.Paper Machine Felt 

About us

Sun Hong is a professional manufacturer and exporter that is concerned with the design, development and production of paper machine spare parts including the industrial fabrics. Products comply with international quality standards and are greatly appreciated in a variety of different markets throughout the world.
Sun Hong Fabric focused on paper and pulp industry with cost-effective products and one by one design solution,help reducing energy consumption,increasing capacity while obtaining excellent ending paper property.
Currently, our products are exporting to Thailand, Brazil, Egypt, Mexico and other Western countries which get good reactions from clients.