Products

GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm

China GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm, Find details about China GPS&Beidou Module, GPS&Beidou Module Antenna from GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm

Model NO.
DL-1616N-GBCM
Package
Plastic Tray , Paper Cartoon
Communication Type
Uart/Ttl
Trademark
DeliNComm
Transport Package
Plastic Tray, Paper Cartoon
Specification
Module Size: 16.1x16.1x6.65mm
Origin
China
Model NO.
DL-1616N-GBCM
Package
Plastic Tray , Paper Cartoon
Communication Type
Uart/Ttl
Trademark
DeliNComm
Transport Package
Plastic Tray, Paper Cartoon
Specification
Module Size: 16.1x16.1x6.65mm
Origin
China
GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm

General Description
     The Delin Comm DL-1616N-GBCM is a complete GPS&Beidou engine module that features super sensitivity, ultra low power and small form factor. The GPS&Beidou signal is applied to the antenna input of module, and a complete serial data message with position,velocity and time information is presented at the serial interface with 
NMEA protocol or custom protocol.
     Its -165dBm tracking sensitivity extends positioning coverage into place like urban canyons and dense foliage 
environment where the GPS&Beidou was not possible before. The small form factor and low power consumption make the module easy to integrate into portable device like PNDs, mobile phones, cameras and vehicle navigation systems.

Applications
  1. LBS (Location Based Service)
  2. PND (Portable Navigation Device)
  3. Vehicle navigation system
  4. Mobile phone
Features
  1. Build on high performance, low-power MediaTek MT3333 chip set
  2. Ultra high Track sensitivity: -165dBm
  3. Extremely fast TTFF at low signal level
  4. Built in high gain LNA
  5. Low power consumption: Max 45mA@3.3V
  6. NMEA-0183 compliant protocol or custom protocol
  7. Operating voltage: 2.8V to 4.3V
  8. Operating temperature range:-40to85ºC
  9. Patch Antenna Size: 15x15x4mm
  10. Module Size: 16.1x16.1x6.65mm
  11. Communication type: UART/TTL
  12. RoHS compliant (Lead-free)
GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm
GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm

  1.2.Power Supply
        Regulated power for the DL-1616N-GBCM is required. The VCC Pin Need a stable DC voltage supply. Power supply ripple must be less than 30mV. The input voltage Vcc should be 2.8V~4.3V, Recommended power supply voltage is 3.3V . maximum current is 45mA. Suitable decoupling must be provided by external decoupling circuitry.
  1.3.UART Ports
       The module supports two full duplex serial channels UART. All serial connections are at 3V CMOS logic levels, if need different voltage levels, use appropriate level shifters. The baud rate of both serial ports are fully programmable, the data format is however fixed: X, N, 8, 1, i.e. X baud rate, no parity, eight data bits and one stop bit, no other data formats are supported, LSB is sent first. The modules default baud rate is set up 9600bps, however, the user can change the default baud rate to any value from 4800 bps to 115kbps. UART port can be used for firmware upgrade, NMEA output and PMTK proprietary commands input.
                                                       
 GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm

GPS&Beidou Module with Patch Antenna with Size 15X15X4 mm


 

You Might Also Like