Customization for  

High Quality IR HDMI KVM Extender Transmitter 100M

Product pannel:

Connection Diagram:

Single LAN cable HDMI extender Cat5e x 1 with sender and receiver 3D HDCP compatible for video extension

Brief introduction:
 HDMI extender extends your HDMI  display up to 50m away from your HDMI source using two Cat-5e/6 cable
This will not only break HDMI cable distance limitations, also the Cat-5e/6 cable installation more flexible and convenient
 use digital video transmission technology without delay, the image is clear and strong anti-interference to give you the picture perfect viewing experience you desire

2. Product features:

• Extend HDMI signal by two Cat5e/6
• The complete module does not need to install
• Implements long distance transmission by Cat5e/6 instead of HDMI cable
• HDCP compatible
• Extends the distance up to 50m,1080p using Cat5e/6 cable
• Small size
• Double transmission speed up to 2.5Gbps, supports 1080p display
• Uses Cat5e cable to connect the local and remote units
• Extends the distance between HDMI source and HDMI display
• Superior video quality - 1920 x 1200p, up to 1080p
• HDMI (3D, deep color), HDCP compatible
• Supports Dolby TrueHD and DTS HD master audio
• DDC compatible

Note: 
In order to achieve perfect transmission effect and long distance, use Cat-5e/6 cable

Packing list

1 * HDMI KVM Extender transmitter
1 * HDMI KVM Extender receiver
1 * DC 12V Adapter
2 * IR transmitter
2 * IR receiver
2 * RS232 plug(3Pins)
1 * User manual

FAQ

Q: Why the direct one to one connection cannot be used?
A: You must use a super Cat5 / 6e network cable (wire sequence T-568B), please check if the addresses of the DIP switches of the transmitter and receiver match
Q: "Check input signal" appear on the screen? (Check input signal)
A: The input signal is inaccessible, please check if the source of the HDMI input signal is connected normally. It is recommended to replace the shorter HDMI cable. Input signal recommended within 5 meters.
Q: (Searching Tx) appears on the screen?
A: The network cable is partially disconnected, please check if the network cable is normal. It is recommended to use Super
Category 5 and Category 6 network cables.

Connect Diagram

* 1 to 1 connection
Set IP address of the transmitter and receivers to the same

* 1 to Many connections
Set IP address of the transmitter and receivers to the same

* Many to Many connections
By using the IGMP network switch, support up to 16 transmitters (Addr: 0000~1111) in one local area network. Set the receivers' IP address to the same as the transmitter which the receiver wants to connect to.