>>>Hair Removal Theory
   E-light hair removal is a new long-term hair removal technology: intense pulsed light to be filtered easily
absorbed by the melanin in the hair and hair follicles and converted to heat, heat can make the hair shaft
and follicle rapid warming, when the temperature reaches above 60 ° C when the cause of hair splitting,
follicle degeneration, dermal papilla damage, hair growth cell death, and finally to the original hair loss,
new hair growth delay, thinning, fades until it does not grow.

Security:IPL technology in use on the basis of a combination of the use of the role of radio frequency
energy depth 15mm depth, so that acts directly on the hair follicle melanocytes absorb more energy,
so small and light, and even gold, white hair has a very good results.


>>> Machine Function
1. Hair Removal: permanent hair removal, throughout the body indecent hair (growth period of hair ),
     including the lighter fine hair.
2. Freckle: get rid of freckles, sun spots, age spots, acne India, facial blemishes.
3. Rejuvenation: improve large pores, rough skin, fine wrinkles, restore skin elasticity.
4. Treat blood capillary expansion: redness, facial flushing.
5. Improve dull complexion, white skin, uniform color.

>>> Advantages
1. Time is short: the first treatment only 20-30 minutes
2. Non-invasive: no trauma to the skin tissue
3. painless: no anesthesia, the treatment only a slight burning sensation
4. No follow-up care: No special postoperative care, immediately after surgery can make.
5. No Side Effects: No physical or chemical treatment of advise reactions
6. The effect is stable: the equivalent of more than ten times otherwise effect
7. Security: E-light system is a combination of high-tech optics medicine and human biological engineeering
technology, change the past, wrinkles and rejuvenation way, deep wrinkles, high safey factor, no pigmentation.


>>>Input water
(1) water source: pure water or distilled water.
(2) Screw off the caps of water inlet and water overflow at the same time, please don't connect the handle,
you should first filled the machine with full water, then connnect the handle
(3) use water pipe and water funnel to input water

Note: when you install the handle, please put the handle down to ground, it will help the water to the top
of handle and in avoid to crash the handle. when you move the machine, please notice to protect the handle,
if the handle fall, the handle will be broken easily.

(4) How to know enought water input?
Please observe water spilt, water spill automatically from the water spilt, means enough water input.
(5) Draw out water pipe and water funnel.

Note: change the whole water every 30 days approximate. add water every week.

>>>Specification

>>>System settings