Products

HDPE Plastic Floating Marina

China HDPE Plastic Floating Marina, Find details about China Plastic Marina, Marina from HDPE Plastic Floating Marina

Model NO.
022
Trademark
new maritime
Specification
50x50x40cm
Origin
China
HS Code
8907900000
Model NO.
022
Trademark
new maritime
Specification
50x50x40cm
Origin
China
HS Code
8907900000
HDPE plastic floating marina

 20'container can loads 250pcs pontoons with accessories.
40' container can loads 500pcs pontoons with accessories.
40HQ container can loads 630 pcs potnoons with accessoies.

 HDPE Plastic Floating Marina

Product specification

Weight

About 7 kilograms (15 pounds)± 5 %

Bearing capacity

360 kilograms per square meter

Colour

Light blue,light gray, orange,can be customized

Material

HDPE

Single buoy size

Length:50cm wide: 50 cm tall: 40 cm

Structural fittings

Claw bolt, anti-collision bolt, side fixing bolt,water ladder, spacer, torque wrench,plug wrench, screw side stiffener, railings, all accessories, Shen anchor fixation group and other equipment installation is very simple.


Advantages:
1.Safety:with patterns on the top surface,Modular Float System is free from dangers 

caused by slippery surfaces,splinters and rusty nails usually found on wooden 

walkways.Also it has no sharp comers and is stable enough to walk on.

2.High Compression: Average compression load is over 1000kg per square meter.

3..Versatility:can be used widely in various fields

4.Economy:free maintenance and low upkeep

5.Convenience /Simplicity of construction: can be easily quickly installed dismantled

6.Durability:resistant to UV rays,frost,seawater,corrosion,chemicals,and oil.

7.Changeability/Resolvability: one connecting pin holds four modules together

permitting the assembly of any size and any configuration on the water the 

assemably can be changed to meet the requirements.

8.Strength:Diagonal lugs' tensile strength is over 1950kg approved by the offical 

authorities; test speed is 50mm/min.This is the Most Important Item to the quality

because the connecting is the foremost factor to the pontoon's quality.
workshop
HDPE Plastic Floating MarinaHDPE Plastic Floating Marina

Anti wind wave:
1.The wave on water surface between 2-class and 3-class belongs to safe applicable range.
2.The wave on water surface between 3-class and 6-class can be applicable; however,the safety protection must be reinforced.
3.The wave on water surface between 6-class and 9-class is the restricted applicable range (it is suggested that the shipping shall not be parked and the visitors shall not be in or out).

Attention: to avoid shaking of the dock, the area of internal lake's dock is not less than 30 square meter; the area of stage is not less than 100 square meter.
HDPE Plastic Floating Marina
anchoring:
1.If water is less than 3m in depth, steel piles are to be put in proper place and then connected by wheels, which can prevent the floating dock from moving laterally but can automatically rise and fall in line with water level.

2.If water is over 3m in depth, anchoring can be used by sinking the anchorage block pulled by steel cables to the water bottom.
Guarantee:
Warranty on our floats are 2 years, that is within three years, if there is any damage caused by the product in normal condition, we will replace the floats for you.

HDPE Plastic Floating Marina

HDPE Plastic Floating Marina

Any question,contact us!

You Might Also Like