China Home Use Sprout Accelerating Device Rice Seed Accelerator Best Price, Find details about China Germinator Seed, Automatic Seed Germinator from Home Use Sprout Accelerating Device Rice Seed Accelerator Best Price
Advantages:
1, microcomputer control time and temperature (timing, temperature setting), real-time monitoring of water temperature.
2. Simple operation and convenient use: this type of accelerating bud does not need special environment or special container. It can be carried out under 220V household power supply.
3. Rapid accelerating of buds to save the time of accelerating buds: under the setting temperature of 32°C, constant temperature increasing of oxygen, buds will sprout within 48 hours (two days).
4. High efficiency and reusable: the speedster has short germination time and can be used repeatedly with very high efficiency.
Model parameters
Use choice | model | Power and voltage | Plastic buckets or water tanks | Reference capacity (L) | Through sowing quantity |
Sprout type | SC300 | 1500w /1220v | 0.7 x0.7 m | 1500L | 300 kg |
Sprout/rice variety | SC600 | 3000w / 220v | 1.5 x0.8 m | 1800L | 600 kg |
Rice seed type | SC1000 | 3500w / 220v | 1.3x1.5 m | 2600L | 1000 kg |
use
1. Place the heating assembly in the bottom center of the container and fasten the isolation cover on the assembly.
2. Put the rice seeds (or other seeds) into the bag, with a maximum of 50-60 jin of seeds in each bag, and put them on top of the heating assembly.
3. The length and width of the container should not exceed 1.3 meters. If it is used outdoors, it is better to keep warm.
4. Put the main engine on a plane higher than the water surface.
5. Connect the air pipe and the temperature control wire. Some air pipes may become loose due to the temperature problem.
6. Plug in the main power supply. The plug board connected to the main power supply should be over 16A, and the wire should be larger than 2.5 square meters, so as to avoid excessive power line heating and ignition.
7. After switching on the power, open the switch of oxygen supply pump. At this time, bubbles will roll up in the container, even and billowing.
8. Press the heating switch of the control handle to energize the heating bar.The heating rod is 3000w/1500w, if tripping, please replace the power line.
9. After pressing the heating switch, the heating lamp above the switch will be red, and it works normally. Due to the large amount of water in the container, the heating speed is slow, so warm water can be injected in advance.
After 48 hours, the seeds will grow uniform small buds. If you soak the seeds in advance, the time may be shortened. Please control the germination time according to the actual situation
About company
Contact us