Plaster Relief Sculpture Mold Making RTV Tin  based Cure Catalysted Silicone Rubber

Mold making silicone rubber for plaster sculpture is primarily intended for poly resin crafts, PU crafts, PU resin crafts, gypsum crafts, unsaturated resin crafts, lighting and candles crafts, plastic toy , stationery gifts crafts industry, a large statue Buddha, relievo furniture, furniture decorative materials, statues Buddha, artifacts copied, building decoration materials, large-scale cement mold, artificial fossils Factory, Europe component factory, simulation landscapes, animals and plants sculpture, sandstone crafts and so on. 

 2.Features of plaster relief sculpture mold making RTV tin cure catalysted silicone rubber :

(1) With SGS and ROHs approval 
(2) Curing agent arrange together as free charged 
(3) In liquid form and in various colors 
(4) With an exceptional fluidity and good operability. 
(5) Temperature and deformation resistance as well as low shrinkage. 
(6) High duplication times. 
(7) Sample are available for free charged
(8) MOQ: 200KG

3.FAQ of plaster relief sculpture mold making RTV tin cure catalysted silicone rubber :

Why does the RTV-2 silicone rubber for molding have few mold making times?

The silicone rubber mold has few molding times is due to follwoing reasons: adding too much silicone oil which will destroy the molecular of silicone rubber; making the mold for small and fine detailed products with higher hardness silicone rubber which is easy to break; making the mold for large products with soft silicone rubber which will reduce the tensile and tear strength of the mold, and the mold will have deformation. Thus, we should take the proper silicone rubber to make the mold for suitable products.

Datasheet:

Operation instruction:

1. Pls clear the model and tool totally before operation to prevent cure inhibition.

2.Weigh the two part correctly by electronic weight in two separate container .

3. Mixing the two part in 100:4 and stir part A and part B evenly in 2-3 minutes .

4.And get the mixture for vacuum-pumping for de-air the bubble in around 2-3

minutes . (If there is no vacuum machine, pls pour the mixture carefully and slowly

down the side of the mold frame so that less bubbles caused)

5. Enclose the product (the original model) with four plastic plates or wooden plates.

6. Clean your products and brush a layer of release agent(detergent or soap water) on

your product.

7. Pour the vacuumed mixture into the model frame from the side of the mold frame .




 

More information(free sample), pls feel free to contact Ms Lisa: