WD-1001M-DIN(T/T4/V3/S/D)

Brief introduction

DIN rail industrial PLC Ethernet bridge is a powerline telecommunication product which developed by WonderTek Technology (KunShan) Co.,LTD., it supports the G.hn protocol and the actual bandwidth up to 400Mbps. The product has been widely used in many aspects just as railway, mines, industrial telecommunication and metro etc...

1.1 Highlight

1.1.1 Technical parameters            

Support G.hn.
Industrial DIN rail style installation.
Actual bandwidth up to 400Mbps.
The maximum transfer distance up to 1000 meters.
Self-adapt the rate.
Compatible with all G.hn devices.
One Domain Master can manage 15pcs End Point.
There can be 16 groups(16 different Domain Master) of PLC telecommunication devices in the same power line circuit.

1.1.2 Manageability

Support Remote Firmware update(TR069).
802.3D Ethernet Bridge.
802.1Q VLAN.
Quality of Service(QoS).
IGMO(IPv4)Snooping&MLD(IPv6)Snooping.
Support local web management.

1.1.3Operating environment

Working temperature:  -40ºC-80ºC.
Operating humidity: 10%-85% no condense.
  Storage humidity:5%-90% no condense.

1.1.4 Design standards

ITU-T G.9960
IEC 60529
IEC 50022
IEC 60068-2-6
MIL-STD-810G
 

Specification:

1.2 Features

(1) Packet loss:≤0.1%(100M,load 70%).
(2) Support 7*24 hours all weather operation.
(3) Hardware watch dog function.
(4) PING≤2MS.
(5) The quantity of the group ≤16pcs.

1.3 Immunity of ESD

The testing voltage which the device should be beared: ±6kV direct Discharge, ±8kV air discharge; 
Discharge number in Each sensitive testing point: Plus-n-Minus 10 times each;
Every time the discharge interval is 1 s.
According to B/T 17626.2-2006.

1.4 Immunity of electrical fast transient impulse group(Common mode)

The testing voltage which the device should be beared:
Between the power supply voltage port and ground: ±2.0kV; 
Between signal circuit and ground: ±1.0kV;
Repetition frequency: 5KHz;
Test duration: 1 min/ time;
Testing times: Plus-n-Minus 5 times each.
According to GB/T 17626.4-2008.

1.5 Anti interference of surge impact

The testing voltage which the device should be beared: ±2kV;
The interval of continuous impulses: 1min/time;
Test number: Plus-n-Minus 5 times each.
According to GB/T 17626.5-2008.(protection: all models protection and varistor series of discharge tube type)

1.6Anti- vibration

Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration,  maximum amplitude 7mm), interface with no loose, device with no Sealing off and drop in the test.

1.7 System topology

WD-1001M-DIN(T)

 

WD-1001M-DIN(T4)

WD-1001M-DIN(V3)

 

WD-1001M-DIN(S)


 

WD-1001M-DIN(D)

Product model selection: