Products

Dzu Solid-Liquid separation Rubber Belt Type Vacuum Filter

China Dzu Solid-Liquid separation Rubber Belt Type Vacuum Filter, Find details about China Vacuum Flter, Rotary Drum Filter from Dzu Solid-Liquid separation Rubber Belt Type Vacuum Filter

Model NO.
DY1000-DY 3000
Tension Pressure
0.2-0.6MPa
Trademark
Leabon
Transport Package
Container
Specification
CE, SGS
Origin
Zhengzhou
Model NO.
DY1000-DY 3000
Tension Pressure
0.2-0.6MPa
Trademark
Leabon
Transport Package
Container
Specification
CE, SGS
Origin
Zhengzhou
Dzu Rubber Belt Type Vacuum Filter

I. Introduction:
The belt filter press is a continuous-feed dewatering device that applies chemical conditioning, gravity draining, and mechanical pressure to dewater sludge. Rubber belt type vacuum filter takes filter bag as filter medium, adopt material gravity and vacuum suction to separate solid and liquid materials.
 
It is adopted ring rubber belt as a vacuum chamber. The vacuum chamber continuously running by motor, filter cloth are layup to the rubber belt and running along with the belt, the rubber belt with friction belt create a water-tight seal. Slurry are distributed on filter cloth by distributing device When the vacuum chamber is switched on vacuum system, it will create a vacuum area on rubber belt, Filtrate liquor pass through filter cloth by horizontal grooves on rubber belt, then get together and go into the vacuum chamber by micro pore, Solid powder are holding on filter cloth, then create a filter cake.
 
The liquid which have got into vacuum chamber be discharged by steam-water separator. Move along with the rubber belt, preformed filter cake get into washing section and suck dry section. Finale filter cloth and rubber belt are divided, the filter cake are discharged from discharging roller. The filter cloth which discharge filter cake are washed ,then can be re-used, re-access to filtrate area by a sets of supportive roller and rectify device, begging a new cycle.

Dzu Solid-Liquid separation Rubber Belt Type Vacuum Filter

 
II. Feature
1. Widely used in solid-liquid seperation
2. Ideal equipment for sludge dewatering
3. Ring type abrasive belt is set between vacuum container and the rubber belt, water is used to airproof and lubricate which can keep stable and higher vacuum degree, good for stable operation state.
4. Rubber belt is supported by air cushion or water to reduce the resistance and is good to prolong service life of the rubber belt.
  1. The whole structure adopts module design which can be consolidated freely, convenient for transportation and installation.
  2. Vacuum balance automatic discharging tank or steam-liquid separator is set to carry out zero potential difference automatic discharging or high potential difference discharging to satisfy requirements from different working states
  3. The control system uses PLC technology to carry out PID regulation, provide safety guarantee of running and supervision of the procedure.Dzu Solid-Liquid separation Rubber Belt Type Vacuum Filter
III. Advantages and characteristics of belt press:
1. Continuous and fully automatic operation
2. High reduction of sludge volume for saving of transport cost
3. High dewatering performance due to the convenient arrangement of the rollers
4. Using the latest advanced technology, add one more independent concentrated device based on normal type belt press, significantly increased the ability of water removal.
5.  8-15% lower flocculation consumption with combination of dynamic and static flocculation reactor.
6. High working capacity (150% of normal type), low moisture content of filter cake (10% less than normal type), low working cost(30% lower than normal type)
7. The frame is made of high quality seamless square steel pipe(10#-12#) with sandblast and high strength fluorin-carbon finish, makes anticorrosive ability keep more than 8 years.
8. The main body are made of stainless steel (304), including main and assistant rollers, fender, flume, waterproof cover, muzzle and sheets, etc.
9. High quality bearing with full airproof bearing seat, available to run more than 3 years.
10. Extrusion and transmission rollers are made of seamless steel pipe with anti-wearing rubber outside, valid to work more than 5 years.
 
 
IV. The belt filter press can be used in the following industrial sectors:
* municipal plants
* pulp and paper industry
* leather industry
* textile processing
* fruit and vegetable processing Kirchen/Germany.
* steel works and roller mills
* sugar industry
* bio-water processing
* Ceramic industry
* Mining industry.
ParameterBelt
width
mm		Motor
power
kw		Belt
tension
KN/m		Running
speed
of belt
m/min		Tension
pressure
Mpa		Washing
pressure
for belts
Mpa		Outline dimension
L*W*H
mm		Weight
kg
Model
DY100010001.1 
 
0-8		 
 
1-9		0.2 
 
0.3-0.5		5250*1950*26305500
DY150015001.50.35250*2450*26306500
DY200020002.20.45250*2950*26307500
DY250025002.20.55250*3450*26308500
DY3000300030.65250*3950*26309500

Dzu Solid-Liquid separation Rubber Belt Type Vacuum Filter

 

You Might Also Like