Science says, remanufacturing is a high technology for waste product repair and transform the industry, it is for damage or to scrap parts, in the performance based on the analysis of the failure analysis, and evaluation of life, etc, for remanufacturing engineering design, adopt a series of advanced manufacturing technology, make the remanufacturing quality of the products meet or exceed the new product.
Remanufacturing engineering is a systematic engineering that comprehensively considers the whole life cycle management of product parts. It is to make use of original parts and remanufacturing molding technology (including high-tech surface engineering technology and other processing technology) to restore the size, shape and performance of parts to form remanufactured products. Mainly include on the new product to use after a remanufacturing old parts, and the long-term use in product performance, reliability and life of the components in the process of recovery and improve by remanufacturing, such as to make the product or equipment in the minimum pollution to the environment, resource utilization, the highest investment under the condition of minimum cost to achieve the best performance requirements. Remanufacturing engineering is regarded as a supplement and development of advanced manufacturing technology and a new industry with great potential in the 21st century.
And remanufacturing is to use advanced technology to remanufacture the whole product after it is scrapped to form a new product. The remanufacturing process can not only improve the service life of the product, but also affect the design of the product, and finally achieve the minimum cost of the whole life cycle of the product, to ensure the maximum benefit of the product. In addition, remanufacturing although there are similar with the traditional recycling environmental targets, but recycling, such as molten steel and dissolve paper mainly material reuse, and components for remanufacturing technology is a kind of functional recovery technique, can get parts from the waste products of the highest value, even for higher performance of remanufacturing products. Thus, remanufacturing is the second investment in products, but also an important measure to make products appreciate.
With thermal spraying technology, existing old parts can be added and remanufactured to restore their size. If the size is restored with a good performance coating, the restored parts will last longer than the original new parts.