Products

GPS & Glonass Engine Module with 1PPS Gnss Module

China GPS & Glonass Engine Module with 1PPS Gnss Module, Find details about China GPS Modules, Gnss Module from GPS & Glonass Engine Module with 1PPS Gnss Module

Model NO.
DM1513-G
Chip Set
Mediatek Mt3333
Package
Plastic Tray , Paper Cartoon
Communication Type
Uart/Ttl
PPS
1PPS
Trademark
DeliNComm
Transport Package
Plastic Tray, Paper Cartoon
Specification
Module Size: 15.2x13.0x6.4mm
Origin
China
Model NO.
DM1513-G
Chip Set
Mediatek Mt3333
Package
Plastic Tray , Paper Cartoon
Communication Type
Uart/Ttl
PPS
1PPS
Trademark
DeliNComm
Transport Package
Plastic Tray, Paper Cartoon
Specification
Module Size: 15.2x13.0x6.4mm
Origin
China

General Description
          The Delin Comm DM1513-G is a complete  GPS&GLONASS engine module that features super
sensitivity , ultra low power and small form factor. The GPS&GLONASS signal is applied to the antenna input
of module , and a complete serial  data message with position, velocity and time information is presented at the  
serial interface with NMEA protocol or custom protocol .
        Its -165dBm  tracking  sensitivity extends positioning coverage into place like urban canyons and dense
foliage environment where the GPS&GLONASS was not possible before. The small form factor and low power consumption make the module easy to integrate into portable device like PNDs, mobile phones, cameras and vehicle navigation systems.
       
Applications
  1. LBS (Location Based Service)
  2. PND (Portable Navigation Device)
  3. Vehicle navigation system
  4. Mobile phone
Features
  1. Build on high performance, low-power MediaTek MT3333 chip set
  2. Ultra high Track sensitivity: -165dBm
  3. Extremely fast TTFF at low signal level
  4. Built in high gain LNA
  5. Low power consumption: Max 40mA@3.3V
  6. NMEA-0183 compliant protocol or custom protocol
  7. Operating voltage: 2.8V to 4.3V
  8. Operating temperature range:-40to85ºC
  9. Patch Antenna Size: 12x12x4mm
  10. Module Size: 15.2x13.0x6.4m
  11. Communication type: UART/TTL
  12. RoHS compliant (Lead-free)
Key Feature
ParameterSpecification
Power Supply
  • Supply voltage: 2.8V~4.3V Typical: 3.3V
Power Consumption
 
  • Acquisition: 40mA @VCC=VBAT=3.3V
  • Tracking: 35mA @VCC=VBAT=3.3V
  • Standby: 2.0mA @VCC=VBAT=3.3V
  • Backup: 15uA @VBAT=3.3V
Receiver Type
  • Code 66 search channels, 22 synchronous tracking channels
  • GPS&&QZSS L1 1575.42MHz C/A , GLONASS L1OF 1602MHz                                                                                      SBAS: WAAS, EGNOS, MSAS, GAGAN

Sensitivity
  • Tracking: -165dBm
  • Re-acquisition: -156dBm
  • Acquisition: -148dBm

TTFF (EASY enabled)
 
  • Cold start: 15s typ @-130dBm
  • Warm start: 5s typ @-130dBm
  • Hot start : 1s typ @-130dBm

TTFF (EASY disabled)
  • Cold start(Autonomous): 35s typ @-130dBm
  • Warm start (Autonomous): 30s typ @-130dBm
  • Hot start (Autonomous): 1s typ @-130dBm
Horizontal Position Accuracy (Autonomous)
  • <2.5m CEP @-130 dBm
Max Update Rate
  • Up to 10Hz,1Hz by fault
Accuracy of 1PPS Signal
  • Typical accuracy: ±10ns, Time pulse width: 100ms
Acceleration Accuracy
  • Without aid: 0.1m/s²

Dynamic Performance
  • Maximum altitude: 18,000m
  • Maximum velocity: 515m/s
  • Acceleration: 4G


UART Port
  • UART Port: TXD and RXD
  • Supports baud rate from 4800bps to 115200bps, 9600bps by default
  • UART port is used for NMEA output, MTK proprietary
  • commands input and firmware upgrade
Temperature Range
  • Normal operation: -40°C ~ +85°C
  • Storage temperature: -45°C ~ +125°C
Physical Characteristics
  • Size: 15.2±0.20 ×13±0.20 ×6.4±0.20mm
  • Weight: Approx. 3.8g

UART Ports

       The module supports two full duplex serial channels UART. All serial connections are at 3V CMOS logic levels, if need different voltage levels, use appropriate level shifters. The baud rate of both serial ports are fully programmable, the data format is however fixed: X, N, 8, 1, i.e. X baud rate, no parity, eight data bits and one stop bit, no other data formats are supported, LSB is sent first. The modules default baud rate is set up 9600bps, however, the user can change the default baud rate to any value from 4800 bps to 115kbps. UART port can be used for firmware upgrade, NMEA output and PMTK proprietary commands input.
                   

Product Picture

GPS & Glonass Engine Module with 1PPS Gnss Module




 

You Might Also Like