Products

Automatic Conveyor Belt Building Machine

China Automatic Conveyor Belt Building Machine, Find details about China Automatic Conveyor Belt Building Machine, Conveyor Belt Forming Line from Automatic Conveyor Belt Building Machine

Model NO.
DCX-1400
Trademark
XIANGJIE
Specification
DCX-1400
Origin
China
HS Code
84778000
Model NO.
DCX-1400
Trademark
XIANGJIE
Specification
DCX-1400
Origin
China
HS Code
84778000

Technical

Let off and winding up device
 
Let off and winding up roller: 600 in diameter, 1400 in length, 90 in shaft head, the roller can be removed, is fixed and the square shaft cannot be removed. Leave 100 at each end (for lanyard).
 
Drive motor: 22kw, frequency conversion control, motor with brake pad, can be reversed, or the clutch can be disengaged.
 
   Winding up speed: 5-30m / min, according to the speed of the compaction roller, the operator manually adjusts the speed at the position of the compaction roller.
   Braking (when open): The brake (electromagnetic) controls the tension (the control switch is located on the pressure roller), the operator can easily manually adjust the clutch's clutch state.
  The distance between the pad winding device and the curling guides on both sides should be 1.5m for the operator to operate.

 Material trolley (4 sets)
   Excessive roller braking: The brake (electromagnetic) controls the tension (the control switch is at the compaction roller), the brake model: FZ400F.
  Cloth take-up motor: torque motor, torque: 250 · (25N.m), can rotate forward, reverse, and separate, manual clutch can pull back the rubber roll. Torque motor model: YLJ132-25 / 4
   Initial pressing roller: diameter 120, working surface length 1800, driven by pneumatic cylinder (diameter 100, stroke 300), pressure can be adjusted by pressure reducing valve, the size between the bottom of the roller and the working surface

  Horizontal movement of the trolley: the movement amount is ± 100, EPC chooses domestic production, model: MT5520-03. The relative position difference of the film during bonding is less than ± 3. EPC1 detects the position of the basic belt and controls the position of the sensor trolley to move along the end of the basic belt. EPC2 controls the position of the bonded material according to the position of the basic belt. Width to adjust the position of the EPC sensor
   The material trolley is on both sides of the traction and compression device, one on each side.
   Cloth liner: maximum width 1400, maximum thickness 0.7, maximum length 220m, maximum roll diameter 400
   Roller: diameter 120, length 1800, through hole 55
    Square shaft: 50 × 50, square shaft can be removed.
The molding table is an iron plate (5), which has been treated with nickel-plated phosphorus to ensure the molding table does not rust.
        All rollers on worktable and material trolley and trolley working shaft are horizontal to the compaction roller.
      The trolley is provided with a prevent overturning structure and adopts a linear guide rail structure.

Automatic Conveyor Belt Building Machine
 

You Might Also Like