• 100% Brand new and high quality.

• It is made of aluminium alloy for strong strength and long durability.

• Used as a adapter for slide hammer or pulling tap for easy catching and pulling.

• A necessary component for dent repair, direct replacement for the broken one.

• Easy installation, the thread size is M10 for better application.

• Material: Aluminum Alloy

• Color:As the picture show

• Type: M10

• Size: As the picture show

• Glue not included( You need to buy the Hot Glue by yourself)

• 1.Clean the dent with a clean wet cloth

• 2.Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes
• 3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the

  drawing gasket is, the larger the drawing force is)

• 4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue)

• 5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter)

• 6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent

• 7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen

• 8. Clean the repaired place with a clean wet cloth

Package Included:

• 1pcs x Slide Hammer

• 18pcs x Blue Glue Gaskets(Glue not included)