Model

W-15m

Booth Dimensions 

- Internal Size

15000×5000×5000 mm (L×W×H) 

- External Size

15150×7770×5900 mm (L×W×H) 

Foundation and Floor 

- Load Capacity

Depends on the concrete of workshop

- Surface Area

16.8 m² , height 660 mm air exhaust boxes at the rear wall

Wall and Door 

- Wall Panel

Double wall panels of galvanized steel sheet, thickness 50 mm, inside and outside white, insulated with Rock-wool, high strength and better fire resistance, with tongue and groove interlocking system, mounted at horizontal.

- Roof Panel

Double wall panels of galvanized steel sheet, thickness 50 mm, inside and outside white, insulated with Rock-wool, high strength and better fire resistance, with tongue and groove interlocking System

- Panel Edging

1.2 mm galvanized plate bending forming

- Entrance Door

2 Units, 4200×4200 mm (W×H), electric rolling shutter, with door interlock switch

- Operator's Door

2 Units, 800×2000 mm (W×H) , observation windows with tempered glass, strengthen metal frame inside, with door interlock switch

- Plenum Area

800 mm Height

Lighting

- Ceiling Lightings

16 Units, each 4×18 W, total 1152 W, LED lamps

- Side Lightings

14 Units, each 2×18 W, total 504 W, LED lamps

- Brightness

> 1000 Lux

- Protection Level

IP 55

Filtration

- Pre-filter

G3 level, Fiberglass, double filters, plate filter + pockets filter

- Ceiling Filters

F5 class filter cotton, Model SP-600G

- Floor Filters

Fiberglass, Paint-Stop-Filters

-Exhaust Filters

Fiberglass paint-resistance filters with large ventilation quantity, small resistance and flame resistance, etc.

Ventilation System 

- Direct Drive Motor (Fresh Air)

2×7.5 kW, 415 V, 50 Hz, ABB motor

- Direct Drive Motor (Exhaust Air)

2×7.5 kW, 415 V, 50 Hz, ABB motor

- Fan Capacity 

50,000 m³/h

- Air Flow Speed 

+/- 0.25 m/s in an empty booth

- Air Duct (Intake & Outlet)

24 meters straight pipe, 4 reducers, 2 pieces rain-proof hat , 4 elbows , 2 pieces electric damper, 2 pieces manual damper

- Noise

< 78 dB

Heating System

- Heat exchanger

Stainless steel 1Gr18Ni9Ti (SUS304)

- Heat capacity

2×315 kW (2×274,000 kcal/h) 

- Max. Drying Temperature 

80 °C

- ΔT Temperature Increasing Capacity

20 °C (from -10°C to 10°C in painting phase)

- Heating time 

5-10 min (from 20 to 60°C) by Drying Phase

- Burner Type

RIELLO FS20 Gas Burner

Control Board (electrical equipment meet AS/ NZS standard)

- Control Standard

Y - Δ Start

- PLC Control

Yes, high reliability & low failure rate

- Pressure Sensor

Pressure gauge indicates the pressure in booth

- Function

Painting(warm painting), evaporation, baking, emergency stop switch, failure indication, over-temperature alarm indication, pre-purge and post-purge

- Frequency Inverter

Excluded (On Option)

Total Power

35 KW