Technical Parameters

·Fingerprint capacity: 120
·Power supply: 4*AA battery or DC5V
·Stand-by mode current: less than 5 uA
·Output: DC5--6V,500mA
 
K200-3.3 VCC and VT is for 3.3V, suitable for R502,R502-A,R503 fingerprint module.

Operation Instruction

1.Press SET button shortly,system in administrator register status and blue indicator light flash fast, press two times for each fingerprint, fingerprint register successfully when hearing music.Fingerprint can be registered continuously,and it can register 20 pieces administrator fingerprint. If no need for adding fingerprint, waiting for 6seconds or press the SET button to exit.
 
2.When back to factory default, press SET button until hear "Di-Di-Di" beep and release the button,means initialization operation successful.
 
3.Register User Fingerprint: Press the administrator fingerprint until hear the music and blue indicator light flash fast, means can add user fingerprint.Press two times for each user fingerprint, fingerprint register successful when hearing music. Fingerprint can be registered continuously, it can register 100 pieces user fingerprint.
 
4.Delete User Fingerprint:Press the administrator fingerprint when hear the music and blue indicator light flash fast, move the finger until hear "DiDiDi" long deep, than all user fingerprints are deleted.
 
5.Mode selection,setby the toggle switch:
a) 1:ON, 2:ON Output DC5V and keep 0.5 second; stop 5 seconds,then minusvoltage outputted and keep 0.5 seconds.
b) 1:ON, 2:OFF Output DC5V and keep 5 second
c) 1:OFF, 2:ON Output DC5V and keep 1 seconds
d) 1:OFF, 2:OFF Keeping output DC5V until removing the finger

6.OPEN(P3):
a) 1:ON, 2:ON Output DC5V and keep 0.5 second; stop 5 seconds,then minusvoltage outputted and keep 0.5 seconds.
b) 1:ON, 2:OFF Output DC5V and keep 5 second
c) 1:OFF, 2:ON Output DC5V and keep 1 seconds
d) 1:OFF, 2:OFF No Output
 
Note:
1.    When the voltage is less than DC4.7V, the red light lightens, means the low voltage warning.
2.    In the "D" mode,when need to register user fingerprint,after press the administrator fingerprint successfully,lifting the finger then press the same administrator finger again until hear the music and blue indicator light flash fast,then it can register user fingerprint.