Product Introduction

The Press joining is a connection to make permanent and not reversible deform of the fittings on the pipe thus leading to a perfect mechanical joint, while the O-Ring provides for the hydraulic tightening connection. Pressing provides for a constant quality joining, easily reproduced and with a minimum physical effort by the operator. Major savings in installation time and cost compared with traditional jointing methods

 A Mixed connection fittings to other systems are made using bronze thread parts with press ends. The thread will be made to meet your local regulation.

Features

a.Material:CC499K (CuSn5Zn5Pb2-C) Bronze
b.A leak free, secure and permanent joint.
c.Flame free installation for ensuring on site safety
d. Inboard with high quality O-Ring for a secure leak free joint when pressed
e. Suitable for use with hard, half-hard and soft copper tubes

3 Reasons to choose Press System

1) Save time, Save money- every connection is made in a fraction of the time when compared to weld, solder or compression systems. On top of this, far less training is needed to use the press tool required for the installation. This means that every installation using the Press System requires less labour, and less cost especially on those larger jobs.

2) A Secure seal in seconds- Every press tool operates differently but one thing stays the same, the strength of the connection. All the installer has to do is cut, calibrate and connect. The press tool will take care of the rest. The auto-cycle feature of most press tools will ensure that every joint is the same, so no guess work needed.

3) Installer safety- The number one concern for any installer when on the job is safety. The Press System offers one of the safest installations on the market. Installations is completely flame free, with no fumes or emissions while installing. This means no fire hazards when installing in occupied premises or retrofits. When the job is all done, there is a faster clean up with no left over waste flux, solder or welding gas.

Pressing Tool

With pressing jaws profile "V"

Installation Instruction

1) Cut copper tubing at right angles using displacement-type cuter or fine-toothed steel saw.

2) Remove burr from inside and outside of tubing to prevent cutting sealing element.

3) Check seal for correct fit. Do not use oils or lubricants.

4) Mark proper insertion depth on tubing.

5) While turning slightly, slide press fitting onto tubing to the marked depth.

6) Insert appropriate jaw into the pressing tool and push in,holding pin until it locks in place.

7) open the jaw and place at right angles on the fittings. Visually check insertion depth using mark on tubing.

8) Start pressing process and hold the trigger until the jaw has engaged the fitting.

9) After pressing, the jaw can be opened again.