Flame retardant plywood wood as the main raw material to produce flame retardant plywood, due to the rationality of the structure and production process of fine processing, can overcome the defects of wood substantially improve greatly and improve the physical and mechanical properties of wood, and flame retardant plywood also overcomes the drawback of ordinary plywood is easy to burn, effectively improve the performance of fire retardant plywood, fire retardant plywood production is full and reasonable use of wood, an important method to improve the performance of wood
Our flame retardant plate is A new kind of building fire prevention board, a-class non-combustible material, does not burn in the fire, fire resistance is extremely high, can effectively block the fire burning and spreading. Waterproof moisture-proof halide, with moisture absorption pores, there won't be water condensation problem in wet weather, put it in the water soak for a few days, can be normal use after dry, does not affect the use effect. Not bad not rot, insect does not decay, is superior to the wooden plank incomparable. Than in gypsum board, the more flexural strength, compressive seismic; More than in the calcium silicon plate is the easy construction, economy is cheap. Sound insulation and heat insulation, alkali resistance to acid, do not contain the formaldehyde, green environmental protection, not to take off on the surface of powder, can brush oil paint, wallpaper, ceramics, wood, all kinds of decorative materials, sawing, nailing, drilling, planing, bending, can stick. Can be used as a smallpox condole top, the bearing indoor outer wall, wall panel and dado, exterior wall hangs Taiwan and outdoor waterproof sheet, at the grass-roots level around the industry for the popular green fire protection products.
Fireproof performance: reach the standard of GB 8624-1997 - A level.


The physical and chemical indicators:
1, (1) dry bending strength more than 11 mpa value, achieve 24 mpa values, qualified
(2) the water saturation is bending strength more than 6 mpa, 18 mpa, qualified
(3) the hygroscopic deformation rate lower than 0.35% values, the result was 0.32%, the qualified
(4) the size of heat shrinkage rate is less than 2.0% of the value, the result was 1.8%, the qualified
(5) the density value is greater than 1.30 / cm3, qualified
2, general specification: 1220 * 2440 * (3 ~ 20) mm
1250 * 2500 * (3-20) mm
Purpose: firewall, decorative ceiling, fire belt, flue, tunnel, in cable trench, etc.