1. Equipment Name:                          Cold  Isostatic Press
2. Equipment type:                        CIP200/300-300
3. Maximum Design pressure:                         300MPa
4. Suggested max working pressure:           270mpa
5. The effective inner diameter of   suppress cylinder vessel: Ø 200mm
6. The effective inner height of   suppress cylinder vessel:               300mm
7. Pressing system Working medium :                      Emulsion(Buyer's own preparation according to requirement)
8. Pressing system driving medium :                    L-HM32 anti-wear hydraulic oil(Buyer's own preparation)
9. No working parts pressure rising time:            0~300MPa,t≤ 2min
10. Assistant time:    upper plug close+ frame move in:t≤ 1.5min  upper plug open+frame remove :  t≤ 1.5min
11. pressure hold time  :          0~9999s Setting freely
12. pressure falls during pressure holding   :     hold  30min,falls≤2% (pressure setable   self-compensation automatically )
13. Control mode:     PLC(Siemens)+HMI(MCGS) / Automatic and Manual mode
14. Supercharging mode:      one - time supercharger , gradable pause
15. Pressure relief mode:     Automatic pressure relief, gradable pause
16. Loading mode:  the upper plug drives the feeding cage to move
17. By CE Certificated with PED directive
18. Install Way:    on floor
19. Power Supply system:   50Hz, 380V, Three-phase five wire system
20. Working condition :    0 ºC~ 45 ºC, Relative Humidity not more than 90%
21. Install Power :           ≈ 15 kw 
22. Install  area:         ≈   6-8 m2
23. Running noise:        ≤ 75dB

 Our main type of press  is as follows:                                  

1. Cold Isostatic Press:a. The vessel inner materials is 34CrNi3MoV alloy whole parts forged and then The forged vessel be wire wounded by alloy of wire(65Mn steel 1.5mm x 6mm size) as per the designed.
b.Whole procedure of the cold isostatic pressing (CIP) machine, increasing, holding and releasing pressure is controlled by PLC and also there is a decompression system to protect the system over pressure to keep the machine in safety running

2. Hot Isostatic Press:
3.  Warm Isostatic Press:a.The vessel inner materials of WIP is 34CrNi3MoV alloy whole parts forged and then The forged vessel be wire wounded by alloy of wire(65Mn steel 1.5mm x 6mm size) as per the designed.
b.Whole procedure of the warm isostatic press machine (WIP ) , increasing, holding and releasing pressure is controlled by PLC and also there is a decompression system to protect the system over pressure to keep the machine in safety running.

Contact Us: