GENERAL ENGINE DATA
Approximate Engine Weight (wet)..............................-kg
Mass Moment of Inertia of Rotating Components (No Flywheel).........…-kg·m2
Center of Gravity from Rear Face of Block........................-mm
Center of Gravity above Crankshaft Centerline.....................-mm
Crankshaft Thrust Bearing Load Limit
-Maximum Intermittent..............................…-N 3425
-Maximum Continuous..............................…-N 1112
Maximum (Static) Bending Moment at Front Support Mounting Surface......-N.m 435
Maximum (Static) Bending Moment at Side Pad Mounting Surface.........-N.m TBD
Maximum (Static) Bending Moment at Rear Face of Block............…-N.m 1356
Moment of Inertia of Complete Engine
- Roll Axis.......................................…-kg·m2 16.5
- Pitch Axis.......................................-kg·m2 41.1
- Yaw Axis....................................... -kg·m2 35.4
Maximum Back Pressure....................................-kPa
Exhaust Pipe Size Normally Acceptable........................…-mm
Maximum Static Supported Weight at the Turbocharger Outlet Flange......-N.m
Exhaust Manifold Insulation Acceptable........................… -Yes/No
Turbocharger Insulation Acceptable...........................…-Yes/No
- Dirty Element...…................................…-kPa
- Clean Element...…................….............… -kPa
Minimum Dirt Holding Capacity with Heavy Duty Air Cleaner............-g/cfm
Maximum Temperature Rise from Ambient to the Inlet of the Turbocharger...-ºC
Recommended intake piping size (inner diameter)................... -mm
LUBRICATION SYSTEM
-Idle Speed....................................…-kPa 207
-Governed Speed.................................-kPa 345
Maximum Oil Temperature...................................-ºC 121
Oil Capacity with OP 9006 Oil Pan : High - Low.........…..............-litre 14.2 - 12.3
Minimum Required Lube System Capacity - Sump plus Filters..........…-litre 16.4
- Front Down.......................................- º 40
- Front Up.......................................…- º 40
- Side to Side.......................................- º 40
FUEL SYSTEM
Type Injection System..........................................… BYC A Direct Injection
Maximum Restriction at Lift Pump...…...........................-mmHg 102
Maximum Allowable Head on Injector Return Line (Consisting of Friction Head and Static Head)
.......................................…-mmHg 508
Total Drain Flow (constant for all loads)..........................…-litre/hr 30
COOLING SYSTEM
Coolant Capacity - Engine Only..............................…-litre 7.9
Maximum Coolant Friction Head External to Engine…-1800 rpm......... -kPa 35
-1500 rpm......... -kPa 28
Maximum Static Head of Coolant Above Engine Crank Centerline......….…-m 14
Standard Thermostat (Modulating) Range..................…....…-ºC 82 - 95
Minimum Pressure Cap.................................... -kPa 69
Maximum Top Tank Temperature for Standby / Prime Power......…........-ºC 104 / 100