The Vacuum Forming Machine is a kind of equipment which can be used in the Department of Stomatology to form a wariety of functional plastic diaphragms. It is a Full-automatic forming equipment and it can save time and protect the operator. The vacuum forming machine adopts the built-in vacuum pump, the users just have to connect the power and it can start the hot pressure molding operation without an external gas source. It adopts push-button operation mode and the built-in molding parameter mode is set for the users to choose.

Technial Parameter:

This portable Vacuum Forming Machine is specially designed for dental applications. Its powerful vacuum
motor provides immediate suction, surely creates accurate materials. Quick and easy vacuum forming for mouth guards, custom trays, base plates, temporary splints, bruxism splints, and copings. It's the necessary dental equipments. This machine will with stand years of rigorous use.

Operation Instruction

1) Connect the machine with power 110V/60Hz, check the status of vacuum motor and electric heating device 
2) Turn the upper cover 90°(from left or right side), then put a film between upper and nether frame ( and ), switch the knob to close the frames tightly.
3) Turn the upper cover back and push down the elevating wrench to elevate the frame to working position (there is a position holder on the principal axes).
4) Take the stainless steel sheet off from the machine, place the product in the middle of the sheet, and then bury the part of the product which you do not need to take shape on. Place the sheet back onto the machine.
5) Switch on the heating device (press the "Heat" button ) to heat the film.
6) Switch off the heating device about 2 - 3 minutes later, when the lower surface of the film is under the nether frame about 2 cm. (The film will sag after heating. The deeper depression, maintain will be more thin.)
7) Switch the elevating wrench to set down the frame and turn on the vacuum motor (press the "Model" button )