Products

Fire Resistance Tester for Wire and Cable IEC60331

China Fire Resistance Tester for Wire and Cable IEC60331, Find details about China IEC60331, IEC60331-11 from Fire Resistance Tester for Wire and Cable IEC60331

Model NO.
GD-60331A
Product Name
Line and Cable Fire Resistance Tester
Trademark
GOLD
Transport Package
Wooden Case
Specification
Fire Resistance Tester
Origin
Chongqing
HS Code
9013809000
Model NO.
GD-60331A
Product Name
Line and Cable Fire Resistance Tester
Trademark
GOLD
Transport Package
Wooden Case
Specification
Fire Resistance Tester
Origin
Chongqing
HS Code
9013809000
             Fire Resistance Tester For Wire And Cable IEC60331

                     Fire Resistance Tester for Wire and Cable IEC60331
Introduction:
Wires and cables that are difficult to catch fire and have the ability to prevent or delay the spread of flame usually refer to the wires and cables that can pass the GB/T18380.3 test. This tester is developed and produced according to the title of IEC 60331,BS EN 50200:2015,BS 8491:2008. It is used to test the integrity of the line when the flame temperature is not lower than 830ºC and the impact vibration is applied.It can test the flame retardancy of A,B, C and D cables.
Standard:
• IEC 60331 
- Test for electric cables under fir conditions - Circuit integrity 
• IEC 60331 Part 11 
- Apparatus - Fire alone at a flame temperature of at least 750˚C 
• IEC 60331 Part 21 
- Procedures and requirements - Cables of rated voltage up to and including 0.6/1kV 
• KWS 409 : Wire of Fire Resistance (Fire-Resistence) - 5.14 Fire resistance test
Features:

Control parameters:

1. Adopt high-voltage electronic automatic ignition with flame detection function, and adopt imported mass flow controller in the gas path to accurately control air and propane flow with an accuracy of 0.39%;Equipped with two sets of pressure reducing valves, control gas pressure at 0.1mpa ±10Pa

2. Equipped with two 1.5mm Omaega K thermocouples to detect flame temperature

3. Automatic control in the test process, automatic ceasefire and air termination, combustion time, water spraying time, hammer period and other time can be set

4. Alarm can be configured. When the test is finished, alarm sound can be issued

5. It has intelligent detection function. When the sample appears in the process of experiment, it will automatically alarm and turn off the fire source in time.

Display: touch screen, display temperature curve

Specification:
- Test Chamber Size : (W) 1,600 x (D) 500 x (H) 500 
- Heat Source : Ribbon type Propane Gas Burner 
- Burner Dimension : (L) 500 x (W) 10 mm / Space of hole : 3.2mm 
- Flame Failure device, Control thermocouples 
- Pilot feed, Gas flow, Rotameter-type flowmeters 
- Auto Ignition system 
- Mass Flow Controller 
; Gas : 15 SLPM / Signal Output : 0 ~ 5V / Accuracy : ±1 % fo F.S 
; Air  : 180 SLPM / Signal Output : 0 ~ 5V / Accuracy : ±1 % fo F.S 
- Electric Control : Transformer & Slidacs : 3 Phase 3 wire, 100~1,000V 
- DAQ System 
; 16 channel Analog Input / Output, 200ks/s 
; 16 channel Digital Input / Output 
- Control Rack : (W) 730 x (D) 650 x (H) 1,400 / 19" Rack / Each Assembly Connector

 

You Might Also Like